Front Panel Indicator: Sw/Led、Pwrled、Speaker - Albatron PM800 Pro (V2.0) User Manual

Mic In is used to connect to a microphone. If the Super 5.1 driver is installed the Mic In becomes the
Subwoofer/ Center out.
This mainboard supports Super 5.1 Channel Audio effects which turns
your standard Speaker Out, Lin In, Mic In audio connectors into a 6
channel audio system. See Appendix I for more information.
Front Panel
Indicator: SW/LED、PWRLED、SPEAKER
The 24-pin connector includes Power-on, Reset, HDD LED, Power LED, Sleep button,
speaker and IrDA Connection. It allows user to connect the PC case's front panel switch
functions.
Pin Assignment
1 +5V
3 N/A
5 N/A
7 Speaker
9 HDD LED (+)
11 HD LED (-)
13 Ground
15 Reset control
17 N/A
19 N/A
21 +5V
23 IRTX
HD LED (Hard Drive LED Header)
This connector can be attached to an LED on the front panel of a computer case. The LED will flicker
during disk activity. This disk activity only applies to those IDE drives directly attached to the system
board.
RST (Reset Button Header)
This connector can be attached to a momentary SPST switch. This switch is normally left open. When
closed it will cause the mainboard to reset and run the POST (Power On Self Test).
PWR_LED
SLP
On/Off
-
+ +
2
1
-
+
SPK RST
HLED
Function Pin
2
4
Speaker
Connector
6
8
10
Hard drive
LED
12
14
Reset
button
16
18
20
IrDA
22
Connector
24
11
PM800 Pro(V2.0)
IR
24
23
IR
JPANEL1
Assignment Function
Sleep control
Sleep
button
Ground
N/A N/A
Power LED (+)
Power LED
Power LED (+)
Power LED (-)
Power button
Power-on
button
Ground
Key
Key
IrDA
Ground
Connector
IRRX