Table of Contents
Advertisement
Chapter 1. Getting Started
Introduction
Congratulations on choosing the PM800 Pro(v2.0) mainboard !These are based on the VIA® PM800
Northbridge chipset and the VIA® VT8237 Southbridge chipset. It supports Intel® Pentium® 4
(Willamette/ Northwood/ Prescott) Processors with a FSB (Front Side Bus) frequency of 400/ 533/ 800
MHz.
The PM800 Pro(V2.0) provide 2 DIMM sockets using 184 pin DDR SDRAM with a total capacity of up to
2GB. You can install unbuffered & non-ECC DDR400/ 333/ 266 (PC3200/ 2700/ 2100) DDR SDRAM.
The PM800 Pro(V2.0) provide one 8X/ 4X (AGP 3.0/ 1.5V or 0.8V ) AGP slot.
The PM800 Pro(V2.0) include built in IDE facilities that support Ultra DMA ATA 66/100/133 and PIO
Modes. It also includes built in Serial ATA facilities that support SATA RAID 0 or RAID 1 and transfer rate
to 150 MB/s per channel.
The PM800 Pro(V2.0) also come with a AC'97 Sound Codec which supports high quality 6 channel audio
(Super 5.1 Channel Audio Effect). It also supports Sony/ Philips Digital Interface (Optional).
The PM800 Pro(V2.0) also comes with a LAN PHY chip (VIA VT6103L)) and provides a back panel LAN
port capable of 1/ 10/ 100 Mbit/s transmission speeds.
The PM800 Pro(V2.0) support eight USB 2.0 ports and also include an infrared header.
All of the information in this manual only for reference. This specification is subject to change without
notice.
2
PM800 Pro(V2.0)
Advertisement
Table of Contents
