Agilent Technologies 3070 System Installation Manual page 96

Chapter 2: MS Windows System Installation Reference: DUT Power Supplies
© Agilent Technologies 2001–2003
To Change DUT Power Supply GPIB Addresses
For 307X systems only where the power supplies are
mounted in a support bay:
• Open the support bay and find the correct power sup-
ply.
Systems without support bays have the power supplies
mounted in the testhead:
• Panels must be removed from the testhead in order to
access the front panel of the power supplies.
To change the GPIB address, press ADDR (beside the
display), enter the desired address on the ENTRY keypad,
and then press ENTER on the ENTRY keypad.
NOTE
If a power supply is split between two modules,
the default GPIB address (and device file) is the
one for the lower-numbered module.
Agilent 3070 System Installation Manual (MS Windows Version) 2-48