Agilent Technologies 3070 System Installation Manual page 35

Chapter 1: MS Windows System Installation Procedure: Setting-Up Other Hardware
© Agilent Technologies 2001–2003
Installing and Removing Test Credit Buttons
E3995A test credit button(s) are installed as shown in
Figure 1-11. One 50k test credit button is included with
the PPU system. It is packaged in a 3-inch by 1.5-inch
box inside a plastic bag containing installation
instructions.
Test credit buttons may be inserted while the system is
running. To insert a button, grasp it with the flange or
labeled side up. Push the button firmly into one of the
Figure 1-11 Installing PPU buttons
Dual Buttons Holder
with cable
Verifying the Test Credit Buttons
From a logon, run a report that tests the
3070service
test credit buttons:
Click Start > Programs > Agilent 3070 > PPU Report?
A report similar to the one shown in
page 1-30 will be displayed in a new window.
1 The E3994A 10k Test Credit Button may also be used and would indicate 10,000 credits.
Agilent 3070 System Installation Manual (MS Windows Version)
ports of the button holder. Save the packaging material
until you are certain that the button is working correctly.
To remove a test credit button, grasp the button by its
flange and pull it straight out of the button holder. To
remove the button holder cable from the button adapter,
deflect one of the retaining latches with your fingernail,
a pen, or similar instrument. The button connector will
pop up for removal.
PPU Buttons
PPU1HH.WPG
Verify that the button label and the button balance are
correct for the number of buttons installed.
identified by the button label number on the button.
Figure 1-12 on
1
Buttons are
1-29