Agilent Technologies 3070 System Installation Manual page 16

Chapter 1: MS Windows System Installation Procedure: Setting Up the KVM and Support Arms
© Agilent Technologies 2001–2003
Table 1-2 Install the KVM and support arms (continued)
Task
7 Connect the KVM cables:
8 Install the barcode scanner
cables:
NOTE
Perform this task only if
installing an optional
barcode scanner.
Otherwise, continue
with Task 9.
9 Tidy and secure all cables.
10 Replace pod cover and
door.
Agilent 3070 System Installation Manual (MS Windows Version)
Step
NOTE
The USB connectors on (the left side of) the video monitor are not used.
a Remove the cover from the rear of the video monitor, then connect the
power and signal cables.
b Replace the rear cover.
c Connect the keyboard and mouse cables.
a Insert the bar code scanner cable between the keyboard cable and the
keyboard extension cable.
b Route the bar code scanner cables through the support arm cable troughs.
Use new cable ties where necessary.
Re-install the pod door and use a T20 Torx driver to replace the pod cover
screws.
1-10