Agilent Technologies 3070 System Installation Manual page 75

Chapter 2: MS Windows System Installation Reference: System Config File Specifics
© Agilent Technologies 2001–2003
NOTE
Changes to the system config file should be
reflected in the standard config file. See
Config File Specifics on page 2-29.
Descriptions of Some Statements in the System
Config File
The Statement
testhead name
The statement in the system config file
testhead name
identifies the block in the
bootptab
hardware and IP addresses for the System Card and
ControlXT/XTP Cards.
The statement in the system config file
testhead name
includes only the modules that are present; for a
four-module system it looks like:
testhead name testhead1 module3 module2
module1 module0
The System Card is represented by
The ControlXT/XTP Card in each module is
represented by
module<n>
Modules are mapped in the
hosts
information, specific hardware addresses can be
determined in the
bootptab
Agilent 3070 System Installation Manual (MS Windows Version)
Standard
file that contains
testhead1
file. Using this
file.
The Statement
line frequency
In this statement, the unused frequency is commented.
For example, if the system power is connected to 60
hertz, is commented.
50
NOTE
"Commented" means that the comment character,
an exclamation mark (!), has been placed at the
beginning of a line.
The Statement
relay
See Vacuum Control on page 2-41.
The < > Statements
cards keywords
These statements identify to the system which cards are
installed and where they are installed.
See Table 2-15 on page 2-43 for available 3070 testhead
cards with diagnostics names,
statements, pattern applications rates and part numbers.
The < > statements can be delimited by
cards keywords
commas (,); a range can be separated by the word "to."
Valid examples are:
I
cards 2, 3, 4, 5 hybrid standard double
density
I
cards 2 to 5 hybrid standard double
density
I
cards 2, 4, 7 to 11 hybrid standard
double density
< >
cards keywords
2-27