Install Wildcat Driver Software - Intergraph Intense3D Wildcat 4210 User Manual

10
To remove Wildcat driver software in Windows NT 4.0:
1. Log on to Windows NT using an account that has administrative privileges.
2. From the operating system Start menu, go to Settings » Control Panel » Add/Remove
Programs » Install/Uninstall.
3. Highlight the Intense3D Display Driver and click Add/Remove.
4. Click Yes when prompted to confirm driver software removal and follow the prompts.
5. Restart the computer.

Install Wildcat Driver Software

To install Wildcat driver software in Windows 2000:
1. Log on to Windows 2000 using an account that has administrative privileges.
2. When the Found New Hardware Wizard displays, click Next.
3. Under Install Hardware Device Drivers, click Search for a suitable driver for my device
(recommended), and then click Next.
4. Under Locate Driver Files, make sure the appropriate search location is selected, and that Disk
1 of the driver media is loaded in the appropriate drive (or the Disk 1 folder is selected); then
click Next. The Wizard locates the driver installation files.
5. Under Driver Files Search Results, click Next to start the installation.
6. Insert Disk 2 when prompted (or select the Disk 2 folder), and then click OK to continue with
the installation.
7. Once the driver successfully installs, click Finish to dismiss the Found New Hardware Wizard.
NOTE Windows 2000 recognizes the dual pipelines as two devices. The Found New
Hardware Wizard will display a second time to finish the installation. You must
repeat Steps 3 through 7 above to complete the installation.
8. When told that the computer must be restarted for the new settings to take effect, remove the
delivery media from the disk drive (if applicable) and click Yes to restart the computer.
See Chapter 3, "Using the Video Card," for instructions on defining the display properties.
To install Wildcat driver software in Windows NT 4.0:
1. Log on to Windows NT using an account that has administrative privileges.
2. Insert the delivery media (diskettes or CD) into the appropriate device on the computer.
3. From the operating system Start menu, go to Settings » Control Panel » Display » Settings »
Display Type » Change.
4. In the Change Display dialog, click Have Disk.