Setup; Preparing For Installation; Make Sure The Computer Is Ready; Collect Materials And Tools - Intergraph Intense3D Wildcat 4210 User Manual

2

Setup

This chapter contains instructions for installing a Wildcat 4210 video card, connecting the
computer's monitors and a stereo display device, and installing the driver software.
If you purchased a Wildcat 4210 as part of a computer, it was installed before shipment along with
the Wildcat driver software. The installation instructions in this chapter are necessary only if you
must install or replace the card or if you must reinstall the Wildcat driver software.

Preparing for Installation

Make Sure the Computer is Ready

General requirements include:
Pentium II or greater processor
Microsoft Windows 2000 or Microsoft Windows NT 4.0 with Service Pack 5 (or later)
Accelerated Graphics Port (AGP) Pro 110 expansion slot
Two open Peripheral Component Interconnect (PCI) slots adjacent to the AGP Pro 110 slot
32 MB DRAM minimum (64 MB recommended)
Industry-standard, multiple-frequency monitor (VGA) or a Digital Video Interface (DVI)-
compliant digital display device
3 MB of free space on the computer's primary system disk for the driver software

Collect Materials and Tools

Make sure you have the following items:
Wildcat 4210 video card
Delivery media containing the Wildcat 4210 video display driver
Flat-head or Phillips screwdriver
Monitor cables supplied with the computer or with the computer's monitors
To connect VGA monitors, 15-pin DVI-VGA adapters for the monitor cables
The computer's documentation
Grounding wrist strap
5