Installing Or Changing The Password - Teledyne 6020 Operating Instructions Manual

Photometric Analyzer
The screen prompts you to enter the current password. If you are not using
password protection, Enter three times to accept TAI as the default password.
If a password has been previously installed, enter the password using the UP/
DOWN
SWITCH
Use Enter to move to the next letter. You cannot go back. If a mistake is
made, Escape to the System menu and return.
When you finish adjusting the last letter, toggle the Enter switch
In a few seconds, you will be given the opportunity to change this pass-
word or keep it and go on.
Escape to move on, or proceed as in Changing the Password, below.
If you want to install a password, or change an existing password, proceed
as above in Entering the Password. When you are given the opportunity to
change the password:
nter to change the password (either the default TAI or the previously
assigned password), or Escape to keep the existing password and move on.
If you chose Enter to change the password, the password assignment
screen appears.
Enter the password using the UP/DOWN
the new password. The full set of 94 characters available for password use are
shown in the table below.
or
to change the first letter.
< < >= >=
< < < >= >= >=
3.3.2.2

Installing or Changing the Password

< < < >= >= >=
< < >= >=
Characters Available for Password Definition:
Teledyne Analytical Instruments
: : : : :
: : : : :
? ? ? ? ?
< < >= >=
< < < >= >= >=
? ? ? ? ?
< < < >= >= >=
< < >= >=
to change the letters to
SWITCH
[ ]
Operation 3
^
Part I 3-7