The Analyze Function; Programming - Teledyne 6020 Operating Instructions Manual

Photometric analyzer

Table of Contents

3 Operation

3.7

The Analyze Function

Normally, all of the functions automatically switch back to the Analyze

function when they have completed their assigned operations. The Escape key

in many cases also switches the analyzer back to the Analyze function.

The Analyze function screen shows the impurity concentration in the first

line, and the range in the second line. In the lower right corner, the abbreviation

Anlz indicates that the analyzer is in the Analyze mode. If there is an * before

the Anlz, it indicates that the range is linearized.

If the concentration detected is overrange, the first line of the display blinks

continuously.

3.8

CAUTION: The programming functions of the Set Range and

Curve Algorithm screens are configured at the facto-

ry to the users application specification. These func-

tions should only be reprogrammed by trained,

qualified personnel.

To program, you must:

1. Enter the password, if you are using the analyzer's password

protection capability.

2. Connect a computer or computer terminal capable of sending an

RS-232 signal to the analyzer RS-232 connector. (See chapter 2

Installation for details). Send the rp command to the analyzer.

3. Enter the System menu.

Use the UP/DOWN switch to blink MORE, then Enter.

Select MORE and ENTER one more time

3-26

Part I

1.95 %

Ñ10

Teledyne Analytical Instruments

Model 6020

Table of Contents

Table of Contents