Operation; Introduction; Using The Controls - Teledyne 6020 Operating Instructions Manual

Photometric Analyzer
3.1
Although the Model 6020 is usually programmed to your application at the
factory, it can be further configured at the operator level, or even, cautiously,
reprogrammed. Depending on the specifics of the application, this might include
all or a subset of the following procedures:
•
•
•
If you choose not to use password protection, the default password is
automatically displayed on the password screen when you start up, and you
simply press Enter for access to all functions of the analyzer.
3.2
To get the proper response from these controls, turn the control toward the
desired action (ESCAPE or ENTER—DOWN or UP), and then release it.
Turn-and-release once for each action. For example, turn-and-release twice
toward UP to move the VFD screen two selections upwards on the list of
options (menu).

Operation

Introduction

Setting system parameters:
• Establish a security password, if desired, requiring Operator
to log in (secure in safe file for referrence).
• Establish and start an automatic calibration cycle, if desired.
Routine Operation:
• Calibrate the instrument.
• Choose autoranging or select a fixed range of analysis.
• Set alarm setpoints, and modes of alarm operation (latching,
fail-safe, etc).
Program/Reprogram the analyzer:
• Define new applications.
• Linearize your ranges.

Using the Controls

Teledyne Analytical Instruments
Operation 3
Part I 3-1