Installation; Unpacking The Analyzer; User Connections - Teledyne 6020 Operating Instructions Manual

Photometric Analyzer
Installation of the Model 6000 Photometric Analyzer includes:
1. Unpacking
2. Mounting
3. Gas connections
4. Electrical connections
5. Testing the system.
2.1
The analyzer is shipped with all the materials you need to install and
prepare the system for operation. Carefully unpack the analyzer and inspect
it for damage. Immediately report any damage to the shipping agent.
2.2
Without Temperature Control, the system must be installed in an area
where the ambient temperature is not permitted to drop below 32°F nor rise
above 110°F.
Regardless of configuration, the system must be installed on a level surface
with sufficient space allocated on either side for personnel and test equipment
access. Subject to the foregoing, the system should be placed as close to the
sample point as possible and bolted to its supporting surface. A waterproof
mastic should be liberally applied to the under surfaces of all four supporting legs
of the cubicle system before placing it in position and bolting it in place.
panel (or cubicle) and appear in the outline diagram in the back of the manual.

Installation

Unpacking the Analyzer

Installing and Connecting the Analyzer

2.2.1 User Connections

All user connections are around the periphery of the equipment
Teledyne Analytical Instruments
Part II: Analysis Unit
Part II: 2-1