MANUAL TRANSMISSION (E - W) -
1
3
5
7
9
2
E
Mitsubishi Motors Corporation
(5) Install the front output shaft to the side gear and fit the
(6) Attach the spacer on the other side gear, then install the
(7) Install the center differential flange on the case while
(8) Measure the backlash between the side gear and the
(9) If the measurement deviates from the standard value,
"DA CENTER DIFFERENTIAL DRIVE GEAR
(1) Apply sealant to the entire threaded portion of the bolt.
(2) Tighten the bolts to the specified torque in the illustrated
10
8
6
4
Jun. 1998
Center Differential <W5M42>
snap ring.
side gear in the center differential case.
NOTE:
If a new side gear is to be installed, select a spacer with
medium thickness (0.93 - 1.00 mm).
aligning the mating marks, then secure it temporarily with
machine screw.
pinion.
Standard value: 0.025 - 0.150 mm
correct the backlash using a spacer of different thickness
and check it again.
NOTE:
The backlash must be the same on both sides.
INSTALLATION
Specified sealant:
3M STUD Locking No. 4170 or equivalent
sequence.
PWEE9508-E
22B-16-3
Added