Spacer/Side Gear/Washer/Pinion/Pinion Holder/ Shaft Installation - Mitsubishi F5M41 Manual

22B-16-2
MANUAL TRANSMISSION (E - W) -
MD998917
MD998823
Differential case
Lock pin
E
Mitsubishi Motors Corporation
AB" TAPER ROLLER BEARING REMOVAL
Use the special tools to remove the taper roller bearing.
MD990930
REASSEMBLY SERVICE POINTS
MB990937
"AA TAPER ROLLER BEARING INSTALLATION
Use the special tool to install the taper roller bearing.
"BA TAPER ROLLER BEARING INSTALLATION
Use the special tools to install the taper roller bearing.
MD998812
"CA SPACER/SIDE GEAR/WASHER/PINION/PINION
(1) Install the side gear in the center differential case with
(2) Fit the washer on the back of each pinion. Engage the
Pinion shaft
(3) Insert the pinion shafts.
(4) Install the lock pins in the illustrated direction.
Jun. 1998
Center Differential <W5M42>
HOLDER/PINION SHAFT/LOCK PIN/FRONT
OUTPUT SHAFT/SNAP RING/CENTER
DIFFERENTIAL FLANGE INSTALLATION
the spacer attached.
NOTE:
If a new side gear is to be installed, select a spacer with
medium thickness (0.93 - 1.00 mm).
4 pinions simultaneously in the side gear.
Rotate the gears to place them in position, then install
the pinion shaft holder.
PWEE9508-E Added