Snap Ring Installatiom; 1St Speed Gear Sleeve Installation; 1St-2Nd Speed Synchronizer Hub Installation - Mitsubishi F5M41 Manual

MANUAL TRANSMISSION (E - W) -
Snap ring
Sleeve
Synchronizer spring
Identification mark
MD998812
MD998814
MD998822
E
Mitsubishi Motors Corporation
"BA SNAP RING INSTALLATION
Select and install a snap ring so that the output shaft front
bearing end play will have the standard value.
Standard value:
"CA 1ST SPEED GEAR SLEEVE INSTALLATION
MD998812
MD998814
MD998822
"DA SYNCHRONIZER SPRING INSTALLATION
Install the synchronizer spring securely up to the illustrated
position of the synchronizer ring.
"EA 1ST-2ND SPEED SYNCHRONIZER HUB
Install the 1st-2nd speed synchronizer hub in such a way
that it will be oriented in the direction shown.
Rear of trans-
mission
Caution
When the hub is installed, make sure that the synchronizer
ring is not caught.
Nov. 1995
Output Shaft <F5M41>
- 0.01 - 0.12 mm
INSTALLATION
PWEE9508-A
22B-7-3
Added