Synchronizer Ring; Synchronizer Sleeve And Hub; Synchronizer Spring; Speed Gears - Mitsubishi F5M41 Manual

MANUAL TRANSMISSION (E - W) -
A

Synchronizer ring

E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
SYNCHRONIZER RING
(1) Check to ensure that the clutch gear tooth surfaces are
(2) Check to ensure that the cone inside diameter is not
(3) Press the synchronizer ring against the gear and check
Gear

SYNCHRONIZER SLEEVE AND HUB

(1) Check to ensure that when the synchronizer sleeve and
(2) Check to ensure that the front and rear ends of the sleeve

SYNCHRONIZER SPRING

Check to ensure that the spring is not sagging, deformed
or broken.

SPEED GEARS

(1) Check to ensure that the helical and clutch gear tooth
(2) Check to ensure that the synchronizer cone surfaces are
(3) Check to ensure that the gear inside diameter and front
Nov. 1995
Jun. 2000
Input Shaft <F5M41>
not damaged and broken.
damaged or worn and that the threads are not crushed.
clearance "A". If "A" is less than the limit, replace.
Limit: 0.5 mm
hub are combined and made to slide, they slide smoothly
without binding.
inside surface are not damaged.
surfaces are not damaged or worn.
not roughened, damaged or worn.
and rear surfaces are not damaged and worn.
PWEE9508-A
PWEE9508-G
22B-5-7
Added
Revised