Mitsubishi F5M41 Manual page 74

22B-8-8
MANUAL TRANSMISSION (E - W) -
Snap ring
A
Synchronizer ring
E
Mitsubishi Motors Corporation
"PA SNAP RING INSTALLATION
Select and install a snap ring so that the output shaft rear
bearing end play will have the standard value.
Standard value:
INSPECTION
OUTPUT SHAFT
Check the splines for damage and wear.
NEEDLE ROLLER BEARING
(1) Check to ensure that when the bearing sleeve and gear
(2) Check to ensure that the cage is not deformed.
SYNCHRONIZER RING
(1) Check to ensure that the clutch gear tooth surfaces are
(2) Check to ensure that the cone inside diameter is not
(3) Press the synchronizer ring against the gear and check
Gear
Jun. 1998
Output Shaft <F5M42, W5M42>
- 0.01 - 0.09 mm
are combined and made to rotate, they rotate smoothly
without looseness and noise.
not damaged and broken.
damaged or worn and that the threads are not crushed.
clearance "A". If "A" is less than the limit, replace.
Limit: 0.5 mm
PWEE9508-E Revised