22B-6-4
MANUAL TRANSMISSION (E - W) -
Identification
groove
Synchronizer hub
MD998801
MD998801
Thrust plate
E
Mitsubishi Motors Corporation
Rear of trans-
mission
Synchronizer sleeve
MD998812
MD998813
MD998824
MD998812
MD998813
MD998824
Jun. 1998
Input Shaft <F5M42, W5M42>
"FA SYNCHRONIZER SLEEVE INSTALLATION
(1) Install the synchronizer sleeve in such a way that it will
be oriented in the direction shown.
(2) When the synchronizer sleeve is installed, make sure that
the deep groove portion of the synchronizer hub is aligned
with the projecting portion of the sleeve.
"GA 4TH SPEED GEAR SLEEVE INSTALLATION
Use the special tools to install the 4th speed gear sleeve.
"HA 5TH SPEED GEAR INSTALLATION
Use the special tools to install the 5th speed gear.
"IA THRUST PLATE INSTALLATION
Select and install a thrust plate so that the input shaft 5th
speed gear end play will have the standard value.
Standard value:
- 0.01 - 0.09 mm
PWEE9508-E
Revised