22B-12-2
MANUAL TRANSMISSION (E - W) -
Lock pin
Control housing
Model
number
stamped
side
2 mm
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
DISASSEMBLY SERVICE POINT
AA" LOCK PIN REMOVAL
Drive the lock pin out of position from the direction shown.
Control finger
REASSEMBLY SERVICE POINTS
"AA NEEDLE BEARING INSTALLATION
Press fit the needle bearing up the illustrated dimension, while
making sure that the model number stamped side is oriented
in the direction shown.
Needle
bearing
"BA OIL SEAL INSTALLATION
Apply transmission oil to the oil seal lip area.
TFM0859
"CA AIR BREATHER INSTALLATION
(1) Apply a sealant to the outside circumference of the inserting
(2) Make sure that the projecting portion is oriented in the
Nov. 1995
Jan. 1997
Control Housing
Transmission oil:
Hypoid gear oil SAE 75W-85W conforming to API
classification GL-4 or higher
portion.
Specified sealant:
3M SUPER WEATHERSTRIP No. 8001 or equivalent
direction shown.
PWEE9508-A
PWEE9508-C
Added
Revised