Automatic Line Selection - Mitel 3000 Installation And Maintenance Manual

A third option, "LCR Weekend" is offered. When this is selected, the LCR service remains active from Friday
night to Monday morning; all off times over the weekend are ignored.

Automatic Line Selection

This feature is programmable off or on. When programmed as "off", the user must dial the line access code after
going off hook before an external line is selected. Default is set "off"
When Automatic Line selection is turned on when an extension goes off hook and dials a number, a free line is
selected automatically and the digits are sent to line. Internal calls are made by selecting the internal call menu on
Featurephone or by pressing Hookflash and dialling the extension number if an analogue phone (POTS) is used.
The Automatic Line Selection feature seizes the line from Outgoing group 1 (9). If this line is busy, it will take
automatically the next free outgoing group.
To program the Automatic Line Selection feature:
•
From the programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "System".
•
Press the Scroll Down key ( ) until "Auto Line Selection" is displayed.
•
Select "Auto Line Selection On".
Press the speakerphone key to finish programming.
To turn Off the Automatic Line Selection feature follow the above steps and select the "Auto Line Selection
Off".
PSTN Programming
This option allows different parameters to be set on standard CO Lines.
Press the speakerphone key to finish programming.
CO Line Programming
Option
Tone Dialing
Loop Calling
Reversal on Idle
Caller ID Detection
Dialtone Detect
Long CO line
Line Name
Break Supervision
Reversal on Answer
While this system is designed to be reasonably secure against CO trunk misuse by
outside callers, there is no implied warranty that it is invulnerable to unauthorized
intrusions and toll fraud.
If the central office does not provide supervision it will not disconnect the call when one
party hangs up; it is possible for a caller to remain connected to a CO trunk circuit. If this
happens, and the caller begins dialing, the call could be placed through the Mitel 3000
System and would then be billed to the system's owner. The system cannot check this type
of call for toll restriction and can not register the call in the call log. This problem could
arise when a call is connected to an extension, when a call is in an unsupervised trunk-to-
trunk call, or when a call is forwarded or transferred to the public network.
Default setting
Tone dialing is set
Loop calling is not set
Off
Caller ID is set
On
Off
Line 1.....
On
Off
103
Installation & Maintenance Manual
Alternate setting
Pulse dialing is set
Loop calling is set
On
Caller ID is not set
Off
On
Any name up to 10 characters
Off
On
Mitel 3000