Mitel 3000 Installation And Maintenance Manual page 119

Mitel 3000
Installation & Maintenance Manual
8. Enter the caller telephone number.
9. Press "Confirm".
10. Enter the name to be associated with the number.
11. Press Confirm.
12. Select the option "Day Mode", "Night Mode" or "Day and Night Mode".
Select the required option of "Extension", "Group", "Auto Attendant" or "Courtesy Service".
NOTE: When selecting "Extension", only one extension can be selected. If more than one extension is required,
then a group would have to be programmed with the required extensions in the group.
Called number routing
If the DID or DNIS service is provided the calls can be routed to extensions or groups based on the called
number, the number the caller dialed.
A table of 100 entries is provided in the DID/DNIS Table programming option. Each entry can be programmed to
ring a group or extension. Courtesy Service or Auto Attendant can also be programmed for each number. If the
received number does not match an entry in the list the call is presented to the group or extension programmed
for the T1 line, or the PRI interface, in the Incoming Ringing programming. The default setting is calls ring
Group 1.
1. From the programming extension, press the PROGRAM key.
2. Press the Scroll Down key ( ) until "System Programming" is displayed.
3. Select "System Programming".
4. Enter the System Programming Password and select "Lines".
5. Press the Scroll Down key ( ) until "DID / DNIS Table" is displayed.
6. Select "DID / DNIS Table".
7. Select an Index Number (001 - 100).
8. Enter the caller telephone number.
9. Press "Confirm".
10. Enter the name to be associated with the number.
11. Press Confirm.
12. Select the option "Day Mode", "Night Mode" or "Day and Night Mode".
13. Select the required option of "Extension", "Group", "Auto Attendant" or "Courtesy Service".
NOTE: When selecting "Extension", only one extension can be selected. If more than one extension is required,
then a group would have to be programmed with the required extensions in the group.
NOTE: With ISDN if the Caller Number field is provided then it will be displayed even if the presentation flag
indicates the number should not be displayed.
Calling number / Called number routing
If both Calling number and Called number services are available, and there are entries in both the CID/ANI and
DID/DNIS tables, then the default setting is that calls are routed based on the calling number if a match is made
in the CLI table. If no match is made in the CID/ANI table then the DID/DNIS table is checked. If a match is
made in the Called number table then the call is routed based on the Called number. If no match is made in either
table the call is presented to the group or extension programmed for the T1 line or the T1 PRI Interface in the
incoming ringing programming. The default setting is calls ring Group 1.
Programming the ISDN Signalling Protocol (Q931) on the T1 PRI
Two ISDN signaling protocols are supported, National ISDN 2 and AT&T 5ESS.
EXCHANGE EQUIPMENT (TELCO)
TRANSLATION PROTOCOL
AT&T 5ESS (AT&T Custom)
AT&T 4ESS (AT&T Custom)
NORTEL CUSTOM (DMS Exchanges) Note 1
NATIONAL ISDN 1 (DMS Exchanges) Note 1
NATIONAL ISDN 2
MITEL 3000 ISDN SWITCH TYPE
AT&T 5ESS (Custom)
AT&T 5ESS (Custom)
NATIONAL ISDN 2
NATIONAL ISDN 2
NATIONAL ISDN 2
114