Technical Specification - Mitel 3000 Installation And Maintenance Manual

Mitel 3000
Installation & Maintenance Manual

Technical specification

Type of system
CO lines
Terminals
Extension capacity
IP Extensions (Mitel 3000 compatible only)
Feature Phone capacity
Standard 2-wire apparatus capacity
Extension loop resistance
System REN
Extension REN
Extension cabling
Main Equipment (CCU) 008
Maximum capacity system 8+32 CCU
Battery
Main AC power supply voltage
Maximum power consumption
Standard 2-wire telephone signaling
Standard 2-wire telephone recall signal
Serial Port
Voice Mail Capacities
Music on hold
Tone on hold
External Music on hold
External Paging Port
System speed dial numbers
Extension current and voltage feed
Dial tone duration
Programming
Remote access
Ringing voltage/frequency
Ringing cadences
Hybrid/PBX
Max 20 CO lines
Max 40 Standard DTMF Telephones
Max 40 ECX 8-key Feature Phones
Max 40 16-key Feature Phones
Max 8 DSS – Additional 32 programmable keys
Max 12 IP phones (Mitel 3000 compatible only)-Broadband module
required.
40
12 (Broadband module required)
40
40
100 ohms (1600 feet) 4-wire Feature Phones
400 ohms (6500 feet ) standard DTMF telephones
> 40
2 (see above for system max.)
Standard 4 wire
2
Twisted pair 0.5 mm cu
Height 15.4 inches (390 mm)
Width 11.6 inches (295 mm)
Depth 6.3 inches (160 mm)
Weight 13.5 pounds (6.1 kg)
Height 15.4 inches (390 mm)
Width 23.4 inches (595 mm)
Depth 6.3 inches (160 mm)
Weight 13.5 pounds (6.1 kg)
12 V/7.2 AH
230 10% V 50 Hz
350 watts
DTMF
Timed break
8 bit, no parity, 1 stop bit speed programmable 115k2
2 Port 5 hours messaging capacity supporting 40 mailboxes, 10 Phantom
Voice Boxes, 20 Group Boxes
4 Port 10 hours messaging capacity supporting 40 mailboxes, 10
Phantom Voice Boxes, 20 Group Boxes
8 Port 20 hours messaging capacity supporting 40 mailboxes, 10
Phantom Voice Boxes, 20 Group Boxes
Maximum message length is default at 3 minutes but is programmable up
to 5 minutes
Internal or External source
200 ms on 200 ms off, 200 ms on 3.4 s off
Stereo jack connector
Input impedance 10k ohm
Nominal 775 mV RMS
Output Level 25 - 32mA Impedance 600 ohm
Max. 500
Voice 40 volts 25 mA constant current
Data 40 volts 10 mA constant current
10 s
Feature Phone (default extension 20) or PC Wizard through serial port
On ISDN or CO lines. (Built-in V32bis modem)
40 V 50 Hz (trapezoid)
Incoming call 400 ms on 200 ms off,
400 ms on 2.0 s off
Internal call 1 s on 2 s off
Door Phone call 400 ms on 2.6 sec off
126