Mitel 3000 Installation And Maintenance Manual page 107

Mitel 3000
Installation & Maintenance Manual
NOTE: VoIP trunks are in outgoing group 2 in default. The group is selected by dialing 760.
To Program PBX Access Digits
1. From the Programming extension, press the PROGRAM key.
2. Press the Scroll Down key ( ) until "System Programming" is displayed.
3. Select "System Programming".
4. Enter the System Programming Password and select "Lines".
5. Press the Scroll Down key ( ) until "PBX Group" is displayed.
6. Select "PBX Group".
7. Select that group you wish to use. You are then presented another menu with which to program the parent
PBX Access digits.
•
Select "Set/Clear PBX Status" to set or clear the selected outgoing group as a PBX group. A
confirmation prompt appears momentarily on the top line of the display.
•
Select "Access Digits". Enter the "Access Digits" for an external line on the parent PBX and select
"Confirm".
•
Select "Ext. Num. Length". Enter the number of digits in the extension numbers on the parent PBX.
Press the speakerphone key to finish programming.
Least-Cost Routing (LCR)
This is a relatively simple implementation of LCR. Up to 50 codes of five digits can be programmed. Each of
these codes can be substituted with a code of up to 9 digits if a different carrier is to be selected for the dialed
code. Alternatively the code can be used to route the call over a particular line. Two time bands can also be
associated with the feature so the option to route the calls using the substitute codes or the alternative lines can be
automatically activated at two different times in a 24 hour period.
To Set up Codes to allow Calls to be routed on Specific Lines or Networks
1. From the programming extension, press the PROGRAM key.
2. Press the Scroll Down key ( ) until "System Programming" is displayed.
3. Select "System Programming".
4. Enter the System Programming Password and select "Lines".
5. Scroll Down and select "LCR Codes".
6. Select "LCR On" to activate the feature.
7. Enter in a code index (01-50).
8. Enter an input code (Up to 5 digits). Press "Confirm". This is the code dialed by the user.
9. Enter an output code (Up to 9 digits). This is the code that will be inserted before the telephone number that
the user dials. This code can be used to select a specific telephone company.
10. Select the preferred or exclusive option.
If "Exclusive" is selected, the calls can only be sent on the lines selected.
11.
12. If "Preferred" is selected, the calls will be routed on any available line, if none of the selected lines are
available. In this case, the output code is not dialed.
LCR Timebands
You can program the Least-Cost Routing feature to be automatically turned on and off twice during a 24-hour
period, enabling you to tailor your call charges through different service providers.
1. From the programming extension, press the PROGRAM key.
2. Press the Scroll Down key ( ) until "System Programming" is displayed.
3. Select "System Programming".
4. Enter the System Programming Password and select "Lines".
5. Scroll down until "LCR Timebands" is displayed.
6. Select "LCR On Times."
7. You can enter two times when the LCR feature is activated.
8. Select "LCR Off Times."
9. You can enter two times when the LCR feature is deactivated.
102