Mitel 3000 Installation And Maintenance Manual page 73

Mitel 3000
Installation & Maintenance Manual
•
Alternate extension
NOTE: The Telesecretary option is presented when a T1 / PRI module is installed. It is not shown if the
system is equipped with CO Lines only.
Lines Settings Options
If "Lines" is selected, the following screens appear:
1.
Select option
- Equipped Lines
- Group programming
- Incoming ringing
3.
Select option
- PBX Group
- LCR Codes
- LCR Timebands
If "Lines" is selected and T1/E1 PRI is programmed, the following screens appear:
1.
Select option
- Equipped Lines
- Group programming
- Incoming ringing
3.
Select option
- PBX Group
- LCR Codes
- LCR Timebands
5.
Select option
- T1 Channels
- System Voice Mail Box
- CID/ANI Table
If "Lines" is selected and E1 PRI is programmed, the following screens appear:
1.
Select option
- Equipped Lines
- Group programming
- Incoming ringing
3.
Select option
- PBX Group
- LCR Codes
- LCR Timebands
5.
Select option
2.
Select option
- Outgoing Restriction
- Incoming Calls Only
- Outgoing Groups
4.
Select option
- CID Programming
- PSTN Programming
- Exit
2.
Select option
- Outgoing Restriction
- Incoming Calls Only
- Outgoing Groups
4.
Select option
- PRI Programming
- Call Routing Priority
- T1 (RBS) or PRI (ISDN)
6.
Select option
- DID/DNS Table
- Exit
2.
Select option
- Outgoing Restriction
- Incoming Calls Only
- Outgoing Groups
4.
Select option
- CID Programming
- DID Programming
- Accept on Busy
6.
Select option
68