Siemens OpenStage 60 SIP User Manual page 104

Enhanced phone functions
Step by Step
Retrieve held call
Disconnect
104
Retrieving a held call:
T
Press the corresponding trunk key. The line key LED
lights up. The call is retrieved.
The LED display
the "Overview" tab
call is on hold to other multi-line telephones
where this line is also configured. These phones
can then pick up the call.
Held call wait status
After placing a call on hold, you can replace the handset
and then decide whether to retrieve the call or discon-
nect.
Prerequisite: You placed a call on hold and replaced the
handset or pressed the loudspeaker key in speaker-
phone mode.
A recall follows immediately and a pop-up menu ap-
pears on the display:
Select and confirm the option shown to retrieve the call
in speakerphone mode.
or
Select and confirm the option shown to disconnect the
held call.
If you enabled "Hold and hang-up" (
the call is placed on hold for a defined time inter-
val (
with a recall to retrieve the call or disconnect. You
can however retrieve the call or disconnect via
the context menu before the defined time ex-
pires.
This function is not considered on multi-line
phones.
page 27 or status display on
page 42 indicates that the
page 106) before the prompt is displayed
page 107),