Can't open pattern
Continue?
Meaning: When you finished recording, it was not
possible to allocate enough memory to open the
pattern that was Put into the track. (When it must be
opened automatically.) If you press the OK button, the
pattern data will be deleted, and the recorded or edited
content will be saved. If you press the Cancel button,
the recorded content will be discarded.
CLIP!
Meaning: The "CLIP!" indication will appear if the
signal level exceeds 0 dB.
• The signal being sampled or recorded to an audio
track has overloaded; use the Recording Level
slider to adjust the level.
Note: When using the analog audio inputs, you will
obtain the widest possible dynamic range if you adjust
the MIC/LINE gain select switch and the LEVEL knobs
as high as possible without allowing "ADC
OVERLOAD!" to appear. In addition, you should set
Level (0–2a) to 127, and adjust Recording Level as
high as possible without allowing "CLIP!" to appear.
CLOCK ERROR!
Meaning: The Global System Clock is set to S/P DIF,
but the clock at the digital input is not being detected
correctly.
D (Destination–Disk)
Destination and source are identical
Meaning: When copying or bouncing, the same song,
track or pattern was selected for both the source and
destination. To solve this problem:
• Select a different song, track, or pattern for the
source and destination.
Destination from-measure within the
limits of source
Meaning: When executing the Move Measure
command for all tracks or within the same track, the
specified destination measure is within the source
range. To solve this problem:
• Set a destination measure that is outside of the
source range.
Destination is empty
Meaning: When editing, the track or pattern that was
specified as the destination contains no musical data.
To solve this problem:
• Select a track or pattern that contains musical data.
Error and confirmation messages D (Destination–Disk)
• Whenever you use digital audio connections, make
sure that all connected systems are set so that there
is one and only one word clock master. You can set
the word clock for the KRONOS using the Global
page System Clock parameter. For more
information, see "System Clock" on page 756 of the
Parameter Guide.
• Make sure that your external device is correctly
transmitting a digital signal.
• Make sure that the sample rate of the external
device is 48 kHz.
• Make sure that there is no problem with the cable.
Completed
Meaning: Execution of the command ended normally.
Could not execute Capture Random
Seed, because the selected Start Seed is
assigned as an RTParam
Meaning: If the KARMA moduleʹs "Start Seed"
parameter has been assigned as a performance
realtime parameter, this message will appear when
you attempt to execute the Capture Random Seed
command; the command cannot be executed. (Press
the OK button to close the message.)
• In the Perf RTP page, cancel the performance
realtime parameter assignment for Start Seed.
Destination measure is empty
Meaning: The measure that was specified as the
destination contains no data.
• Specify a destination measure that contains data.
Destination multisample already exists
Meaning: A multisample already exists at the
destination (save location) multisample.
• Either delete the multisample at the destination
(save location), or change the save destination
multisample number.
Destination multisample and source
multisample are identical
Meaning: The same multisample is selected for the
source and destination.
• Select different multisamples for the source and
destination.
Destination sample already exists
Meaning: A sample already exists at the destination
(save location).
257