and are using an external effect processor to apply
reverb or chorus to the sound, you can turn off the
KRONOS's master effects and total effects.
Tuning and transpose
settings
Velocity/aftertouch curve
settings
Effect bypass settings
Select the mode that is
selected at power-on
Beep setting
Linking KARMA to Programs and
Combinations
You can specify whether the KARMA settings written
to a program or combination will also be selected when
you select that program or combination, or whether the
KARMA settings will not change when you switch the
program or combination.
When the KRONOS is shipped from the factory, the
former setting is selected. You can use the latter setting
if you want to use the same KARMA settings to
generate phrases and patterns while you select and try
out different programs and combinations.
If the Load KARMA Settings When Changing
Program or Combination boxes are selected, selecting
a program or combination respectively will also select
the KARMA settings that are written in that program
or combination.
Globally disabling KARMA and the
Drum Track
If All KARMA/DT Off is checked, all KARMA and
Drum Track functionality will be turned off. KARMA
will not start even if the KARMA ON/OFF switch is on,
and the Drum Track will not start even if the DRUM
TRACK ON/OFF switch is on.
Recalling the last-selected mode and
page at power-on
The state of KRONOS when the power is turned on
will depend on the setting of "Power On Mode".
If Power On Mode is set to Reset (factory setting),
KRONOS will automatically select the Set List mode
P0: Play page.
Global Settings Basic Setup
If the Effect Global SW IFX 1–12 Off, MFX1&2 Off,
and TFX1&2 Off items are checked, the insert effects,
master effect, will respectively be bypassed.
If Power On Mode is set to Memorize, KRONOS will
power on using the same mode and page that were
selected when the power was turned off.
Sounding a beep when you press the LCD
screen
If Beep Enable is selected, a beep will sound when you
press an object in the LCD screen. Uncheck this item if
you don't want a beep to sound.
Protecting the memory
If one or more of the Memory Protect check boxes are
checked, operations such as writing, loading, or song
recording will be prohibited for the corresponding
type of memory.
Adjusting the brightness of the LCD
You can adjust the appearance of the LCD display by
using the LCD Setup menu command, on the Global
Basic Setup page. To do so:
1. Press the GLOBAL switch to enter Global mode.
2. Press the Basic tab in the lower line, and then the
Basic tab located above it.
The Global Basic Setup page will appear.
3. From the page menu located in the upper right of
the LCD, choose LCD Setup.
The LCD Setup dialog will appear.
4. Set the brightness as desired
5. Press the OK button to confirm the changes, or
press the Cancel button to revert to the previous
settings.
KARMA &
Drum Track settings
Memory protect
settings
159