Appendices
Not enough sample memory
Meaning: There is insufficient sample memory (for
sample parameters or sample waveform data).
• Delete samples to increase the amount of free
memory.
Not enough sample/multisample
locations available
Meaning: The data you attempted to load would
exceed the maximum number of multisamples or
samples. To solve this problem:
• In Sampling mode, use Delete Multisample or
Delete Sample to free a sufficient number, and
reload the data.'
Not enough song locations available
Meaning: When loading a .SNG file with Append
specified, you attempted to load more songs than can
be loaded.
Meaning: When executing Auto Song Setup, a new
song could not be selected automatically because there
was no song with the default settings. This can be
O (Obey copyright rules–Oscillator)
Obey Copyright Rules
Meaning: When you execute the Disk mode Make
Audio CD page Write to CD command, or when you
execute Destination in the Sampling mode Audio CD
page Destination command.
Please read "COPYRIGHT WARNING" on page 3 of
the Quick Start Guide before you use this data.
P (Pattern–Program)
Pattern conflicts with events
Meaning: It was not possible to execute the Bounce
operation because one of the tracks contained a
pattern, and the same measure of the other track
contained events or a pattern.
• Open the pattern.
Pattern exists across destination to-end-
of-measure or source from-measure
Meaning: When moving a measure, the edit operation
could not be executed because a pattern had been put
in the destination end measure or the source start
measure, and had not been opened.
• Open the pattern.
264
caused by using the Global mode "Change all bank
references" command with the Song option selected,
since this modifies the settings of all songs away from
the defaults; after this, the system will not recognize
those songs as being empty and available.
• In Sequencer mode, use the Initialize Song
command to increase the number of Songs that can
be used, and then load the song again.
Not enough song memory
Meaning: When executing the Sampling mode Time
Slice or Save commands, the total data for all songs
occupies all of the sequence data memory area, so that
saving is not possible.
Meaning: When sampling to RAM in Sequencer mode,
it is not possible to create track data at the same time.
• Increase the amount of free memory, for example
by deleting another song.
No unused WAVE files found
Meaning: When you executed the Disk Utility page
menu command Delete Unused WAVE files, no
unused WAVE files were found.
Oscillator Mode conflicts (Check PROG
P1)
Meaning: In Sampling mode when you executed
Convert MS To Program with Use Destination
Program Parameters checked, the conversion
destination program Oscillator Mode setting did not
match.
• In Program mode, set the Oscillator Mode of the
conversion destination program. If converting a
monaural multisample, select Single. If converting a
stereo multisample, select Double.
Pattern exists in destination or source
track - Open pattern?
Meaning: A pattern has been placed in the track that
you specified as a destination or source for editing. If
you wish to open the pattern and execute (the events of
the pattern will be copied), press the OK button. If you
wish to execute without opening the pattern, press the
Cancel button.
Pattern used in song - Continue ?
Meaning: When editing, the specified pattern has been
placed in a track. If you wish to execute, press the OK
button. If you decide not to execute, press the Cancel
button.