D (Destination-Disk) - Korg kronos Operation Manual

CLIP!
Meaning: The "CLIP!" indication will appear if the signal
level exceeds 0 dB.
• The signal being sampled or recorded to an audio track
has overloaded; use the Recording Level slider to adjust
the level.
Note: When using the analog audio inputs, you will obtain
the widest possible dynamic range if you adjust the
MIC/LINE gain select switch and the LEVEL knobs as high
as possible without allowing "ADC OVERLOAD!" to
appear. In addition, you should set Level (0–2a) to 127, and
adjust Recording Level as high as possible without allowing
"CLIP!" to appear.
CLOCK ERROR!
Meaning: The Global System Clock is set to S/P DIF, but
the clock at the digital input is not being detected correctly.
• Whenever you use digital audio connections, make sure
that all connected systems are set so that there is one and
only one word clock master. You can set the word clock
for the KRONOS using the Global page System Clock
D (Destination–Disk)
Destination and source are identical
Meaning: When copying or bouncing, the same song, track
or pattern was selected for both the source and destination.
To solve this problem:
• Select a different song, track, or pattern for the source
and destination.
Destination from-measure within the
limits of source
Meaning: When executing the Move Measure command for
all tracks or within the same track, the specified destination
measure is within the source range. To solve this problem:
• Set a destination measure that is outside of the source
range.
Destination is empty
Meaning: When editing, the track or pattern that was
specified as the destination contains no musical data. To
solve this problem:
• Select a track or pattern that contains musical data.
Destination measure is empty
Meaning: The measure that was specified as the destination
contains no data.
• Specify a destination measure that contains data.
Destination multisample already exists
Meaning: A multisample already exists at the destination
(save location) multisample.
Error and confirmation messages D (Destination–Disk)
parameter. For more information, see "System Clock" on
page 756 of the Parameter Guide.
• Make sure that your external device is correctly
transmitting a digital signal.
• Make sure that the sample rate of the external device is
48 kHz.
• Make sure that there is no problem with the cable.
Completed
Meaning: Execution of the command ended normally.
Could not execute Capture Random
Seed, because the selected Start Seed is
assigned as an RTParam
Meaning: If the KARMA module's "Start Seed" parameter
has been assigned as a performance realtime parameter, this
message will appear when you attempt to execute the
Capture Random Seed command; the command cannot be
executed. (Press the OK button to close the message.)
• In the Perf RTP page, cancel the performance realtime
parameter assignment for Start Seed.
• Either delete the multisample at the destination (save
location), or change the save destination multisample
number.
Destination multisample and source
multisample are identical
Meaning: The same multisample is selected for the source
and destination.
• Select different multisamples for the source and
destination.
Destination sample already exists
Meaning: A sample already exists at the destination (save
location).
• Either delete the sample at the destination (save
location), or change the save destination sample number.
Destination sample data used in source
sample
Can't overwrite
Meaning: Since the sample data at the destination (save
location) is also used by the source sample, it cannot be
overwritten.
• Without using Overwrite, specify a different sample for
the destination (save location).
Destination sample is empty
Meaning: The sample for editing is empty.
269