Controlling The Effect Parameters - Korg MMT RADIAS Owner's Manual

Effect guide
Delay time for the insert effects
Broadly speaking, there are two types of effect for which
you can specify a delay time.
• Delay effects
• Modulation effects such as chorus that internally
use a fixed delay time
If you use such an effect in the two insert effects, the de-
lay time of the effects can be set for a maximum of 1.0
seconds for each timbre.
Here are some examples.
• Insert effect 1 uses St.Delay, and insert effect 2 uses
St.Auto Panning Delay. 500 ms of delay time is
assigned to each effect.
IFX1
St. Delay
500 msec
• Insert effect 1 uses St.Chorus, and insert effect 2 uses
St.Delay. 160 ms of delay time is assigned to St.Cho-
rus, and 840 ms of delay time is assigned to
St.Delay.
IFX1
St. Delay
Controlling the effect parame-
ters
You can use the front panel INSERT FX [EDIT 1] and
[EDIT 2] knobs to control insert effect parameters in re-
altime, and the front panel MASTER FX [EDIT] knob to
control a master effect parameter in realtime. Parame-
ters assigned to these knobs can also be controlled from
an external MIDI device.
You can make assignments for these knobs in the Pro-
gram Edit mode P13–2, 3: EQ/FX – IFX1, IFX2 tab page
"Edit1" and "Edit2," and in MFX tab page "Edit." The
parameters you can assign will depend on the effect
type you're using.
For details on the parameters you can assign to these
knobs, refer to p.123 "Effect parameters."
Noise may occur if a parameter not assigned to a
knob is operated while sound is being produced.
122
IFX2
St. Auto Panning Delay
500 msec
1.0 sec
IFX2
St. Chorus
840 msec
160 msec
1.0 sec