Image Menu - InFocus IN5542 User Manual

IMAGE menu

IMAGE menu
From the IMAGE menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons on the
projector or remote control, and press the ► cursor
button on the projector or remote control, or ENTER
button on the remote control to execute the item.
Follow the instructions below.
Item
ASPECT
OVER SCAN
V POSITION
H POSITION
34 (continued on next page)
Using the ▲/▼ buttons switches the mode for aspect ratio.
For a COMPUTER signal
NORMAL ó 4:3 ó 16:9 ó 16:10*
For an HDMI or DVI-D signal
NORMAL ó 4:3 ó 16:9 ó 16:10* ó 14:9 ó SMALL* ó NATIVE* ó FULL*
For a Video signal, S-video signal or component video signal
4:3 ó 16:9 ó 16:10* ó 14:9 ó SMALL* ó NATIVE* ó FULL*
For no signal
4:3 (fixed, except IN5544/IN5544c) / FULL (fixed, IN5544/IN5544c)
• *16:10 / FULL: IN5544/IN5544c only. NATIVE: Except IN5542/
IN5542c. SMALL: Except IN5544/IN5544c.
• The NORMAL mode keeps the original aspect ratio of the signal.
Using the ◄/► buttons adjusts the overscan ratio.
Small (It magnifies picture) ó Large (It reduces picture)
• This item can be selected not only for a video, S-video and component signal but also
HDMI and DVI-D signal when the VIDEO is selected on the DIGITAL FORMAT item (37).
• When this adjustment is too large, certain degradation may appear
at the frame area of the picture. In this case, please adjust small.
Using the ◄/► buttons adjusts the vertical position.
Down ó Up
• Over-adjusting the vertical position may cause noise to appear on the screen. If this
occurs, please reset the vertical position to the default setting. Pressing the RESET
button when the V POSITION is selected will reset the V POSITION to the default setting.
• When this function is performed on a video signal, S-video signal, or component video
signal of 480i@60 or 576i@50 input the adjustment range depends on the OVER SCAN
(above) setting. It is not possible to adjust when the OVER SCAN is set to 10.
• This item cannot be selected for an HDMI or DVI-D signal.
Using the ◄/► buttons adjusts the horizontal position.
Right ó Left
• Over-adjusting the horizontal position may cause noise to appear on the screen. If this
occurs, please reset the horizontal position to the default setting. Pressing the RESET
button when the H POSITION is selected will reset the H POSITION to the default setting.
• When this function is performed on a video signal, S-video signal, or component video
signal of 480i@60 or 576i@50 input the adjustment range depends on the OVER SCAN
(above) setting. It is not possible to adjust when the OVER SCAN is set to 10.
• This item cannot be selected for an HDMI or DVI-D signal.
Description
SMALL* ó NATIVE* ó FULL*
ó