Remote Control; Putting Batteries - InFocus IN5542 User Manual

Remote control

Remote control

Putting batteries

The remote control needs two batteries of the following type.
Hitachi Maxell or Hitachi Maxell Energy part number AA Alkaline (LR6 or R6P)
Batteries not included.
The following walks you through loading batteries into the remote control.
1.
Remove the battery cover in the back of the
remote control. Push lightly the knob of the
battery cover while pulling it up.
2.
Put the batteries into the battery holder, according to the
polarity markings "+" and "-" inside the holder.
3.
Put the battery cover back into place until it clicks.
NOTE
• If the remote control malfunctions, try replacing the batteries with
fresh ones.
WARNING
batteries. It is dangerous if a laser beam is unintentionally turned on. Please
refer to the section "Laser pointer" (18).
►Be careful when handling batteries, since a battery can explode, crack or leak
possibly causing a fire, injury, or environmental pollution.
• Use only the specified batteries. Do not use batteries of different types.
• When replacing, replace both of the batteries with new batteries of the same
type. Do not use a new battery with a used battery.
• Do not use a battery with damage, such as scratches, dents, rust or leakage.
• Make sure the plus and minus terminals are correctly aligned when loading a
battery.
• Do not work on a battery; for example recharging or soldering.
• If the remote control is not used for a long period of time, remove the batteries.
• Keep batteries in a dark, cool and dry place. Never expose a battery to a fire or
water.
• Keep batteries away from children and pets.
• When a battery leaks, wipe the leakage out well with a waste cloth. If the
leakage adhers to your body, immediately rinse it well with water. When a battery
leaks in the battery holder, replace the batteries after wiping the leakage out.
• Obey the local laws when disposing a battery.
16
►Be careful not to press the LASER button when loading the