Using The Remote Id Function; Using As A Wired Remote Control; Laser Pointer - InFocus IN5542 User Manual

Remote control

Using the REMOTE ID function

This function defines which projector is controlled by the remote control. Utilize this
function when you use multiple projectors of the same type simultaneously.
1.
Set the ID number to the projector beforehand,
referring to the item "REMOTE ID" item (52).
2.
Press a ID button on the remote control. The ID button
selected will light for 3 seconds.
NOTE
• Each time you press any button (except ID buttons), the ID button of
current selected ID number will light.
• To confirm the projector's current ID, press any ID button for 3 seconds. Its
number will be shown on each screen regardless of set ID of projector.

Using as a wired remote control

The accessory remote control works as a wired remote control,
when the wired control port at the bottom of the remote control
is connected to the REMOTE CONTROL port on the back of the
projector via a 3.5mm stereo audio cable.
This function is useful when a wireless remote signal
may not reliably reach the projector.
NOTE
• To connect the remote control with the projector, use an audio cable
with 3.5 diameter stereo mini plugs.

Laser pointer

Instead of using a finger or pointer, the remote control's laser pointer can be used.
When the LASER button is pressed, the laser beam and the LASER INDICATOR
lights.
C A U T I O N
C A U T I O N
LASER RADIATION-
LASER RADIATION-
DO NOT STARE INTO BEAM
DO NOT STARE INTO BEAM
MAX. OUTPUT: 1mW
or MAX. OUTPUT: 1mW
WAVE LENGTH: 650nm
WAVE LENGTH: 650nm
CLASS2 LASER PRODUCT
CLASS2 LASER PRODUCT
LASER RADIATION
LASER RADIATION
DO NOT STARE INTO BEAM DO NOT STARE INTO BEAM
CLASS2 LASER PRODUCT CLASS2 LASER PRODUCT
MAX OUTPUT : 1mw MAX OUTPUT : 1mw
WAVE LENGTH : 650nm
WAVE LENGTH : 650nm
IEC60825-1 :1993 + A1 : 1997 + A2 : 2001
IEC60825-1 :2007 EN60825-1:2007
ビームをのぞきこまないでください。
ビームをのぞきこまないでください。
最大出力 １ｍW 最大出力 １ｍW
波長 ６５０ n m
波長 ６５０ n m
クラス２レーザ製品
クラス２レーザ製品
JIS C 6802:1997/98
JIS C 6802:2005
WARNING
screen. Do not point the laser beam at anything except the screen.
• Never hit eyes with the laser beam since the laser beam can injure eyes.
• Do not point the laser beam at anything except the screen.
18
►Only use the remote control's laser beam to point at the
HDMI
I O
AC IN
Laser aperture
LASER INDICATOR
LASER
INDICATOR
STANDBY/ON MY SOURCE COMPUTER
ID 1 ID 3
ID 2 ID 4
BLANK
ENTER
FREEZE
SHUTTER
ASPECT
PbyP AUTO
LAN
MY BUTTON
MONITOR
DVI-D
OUT
CONTROL IN CONTROL OUT REMOTE
S-VIDEO
CONTROL
1 3
IN
COMPUTER IN1 COMPUTER IN2
OUT
BNC
VIDEO 1
2 4
R/Cr/Pr G/Y B/Cb/Pb H V VIDEO 2
Y
Cb/Pb
Cr/Pr
KEYSTONE
FOCUS ZOOM
+ +
LENS SHIFT
- -
LASER button
VIDEO
DIGITAL
LASER
MENU
RESET
POSITION
MAGNIFY
ON
OFF