IMC Networks AccessEtherLinX Operation Manual page 12

Accessetherlinx series
Hide thumbs Also See for AccessEtherLinX:
Table of Contents

Advertisement

then issue an IP address to the management card. Once the new IP address is
received, the SNMP Management Module will reboot so that the new IP address will
take effect. Refer to the About Serial Port Configuration for more information about
Enabling/Disabling DHCP. When there is no DHCP server on the network, use
iConfig or serial configuration to manually set the IP addresses.
When DHCP is enabled, the IP address (default 10.10.10.10 or user configured) is
saved. When DHCP is disabled, the saved IP address will be reinstated and the
device will reboot.
DHCP servers give out lease times: devices renew their leases based on the
administrator-specified time. If a device cannot renew its lease, and the lease
expires, the device will be given the IP address 10.10.10.10 and will reboot.
Ending a Session
Be sure to press E before disconnecting the cable in order to stop the continuous
stream of data to the serial port.
Additional Device-Specific Options
The iMediaChassis series also includes device-specific options. Press the Space Bar
when in the Command List section of the Main Configuration screen (serial
configuration/Telnet session), type the name of the action, and press Enter.
Device-Specific Configuration Options
The Managed Port Multiplier also includes several device-specific options. To access
these options, press the Space Bar from the Command List section of the Main
Configuration screen, type the name of the action you want to perform (as shown
below) and press Enter.
9

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AccessEtherLinX and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Products for IMC Networks AccessEtherLinX

This manual is also suitable for:

Accessetherlinx 4

Table of Contents