Failover Status
Not HAFO dev
This status message indicates that the Ldev on the path is not a high availability
array. The list of supported arrays is documented in the "System Requirements"
section of this document.
Ldev Not Validated
The Not Validated status is shown when HAFO is unable to validate both
hardware paths (at boot time or during
command).
DOHA
Unknown Status
HAFO/iX has been written to account for a large number of known errors. It is
possible that new error conditions may arise that are, by definition, unknown.
This should be a very rare condition. If this condition occurs, be sure to save
your system log files from the time of this error and then contact your HP
Support representative to report the problem.
40