HP e3000 MPE/iX Manual page 57

1006 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 1006)
CAUSE: An error occurred while attempting to release a message frame
allocated for HAFO Utilities.
ACTION: Call your HP Support Representative for assistance.
1007 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 1007)
CAUSE: An error occurred while attempting to send an I/O Request to the
Device Manager.
ACTION: Check to make sure that there are no mismatches between the
SYSGEN (io) section) configuration and the HAFO (ha) section configuration.
All HAFO (ha) configured primary paths must match the SYSGEN (io) path
configuration for all HAFO Ldevs.
Check that there are no hardware problems and make sure no failover events
have occurred. If a failover event has occurred, fix the primary path and make
sure all HAFO Ldevs are operating on their primary path.
If the HAFO primary and SYSGEN (io) paths are in sync and all HAFO Ldevs
are operating on their primary paths, then call your HP Support Representative
for assistance.
1008 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 1008)
CAUSE: An error occurred while waiting for an I/O request to the Device
Manager to complete.
ACTION: Check to make sure that there are no mismatches between the
SYSGEN (io) section configuration and the HAFO (ha) section configuration.
All HAFO (ha) configured primary paths must match the SYSGEN (io) path
configuration for all HAFO Ldevs.
Check that there are no hardware problems and make sure no failover events
have occurred. If a failover event has occurred, fix the primary path and make
sure all HAFO Ldevs are operating on their primary path.
If the HAFO primary and SYSGEN (io) paths are in sync and all HAFO Ldevs
are operating on their primary paths, then call your HP Support Representative
for assistance.
Appendix-B
57