Gonext (Go) - HP e3000 MPE/iX Manual

GONEXT (go)

The
path to the "Validated" path according to the HAFOCONF file.
The most important use of this command is after the repair of a "failed" primary
path.
primary path.
activities to temporarily switch from the primary path to the alternate path. This
command is fully documented in Chapter 6, "Recovering From a Failure."
HAFO protection is only available on the primary path! Use the
WARNING
command to switch to the alternate path with caution. You should never
intentionally run your system using the alternate path for extended periods of
time.
WARNING
GONEXT
reason. Attempts to force usage of a "broken" path may result in the need to do a
full System Reboot to reinitialize the MPE/iX I/O configuration.
command causes the Ldev to switch from the current, "Ready",
GONEXT
switchs the Ldev from using the alternate path back to using the
GONEXT
can also be used during preventative maintenance
GONEXT
should NOT be used to "force" HAFO to use a known bad path for any
Configuration
GONEXT (go)
GONEXT
29