HP e3000 MPE/iX Manual page 52

Appendix - B
10 MESSAGE: Invalid character in Alternate path parameter — (HAFOERR
10)
CAUSE: Parameter 3 has an invalid value.
ACTION: Input correct Parameter 3 value with command.
11 MESSAGE: Ldev parameter too long — (HAFOERR 11)
CAUSE: Parameter 1 has an invalid value.
ACTION: Input correct Parameter 1 value with command.
12 MESSAGE: Primary Path parameter too long — (HAFOERR 12)
CAUSE: Parameter 2 has an invalid value.
ACTION: Input correct Parameter 2 value with command.
13 MESSAGE: Alternate Path parameter too long — (HAFOERR 13)
CAUSE: Parameter 3 has an invalid value.
ACTION: Input correct Parameter 3 value with command.
14 MESSAGE: Invalid Primary path for this Ldev — (HAFOERR 14)
CAUSE: Parameter 2 has an invalid value.
ACTION: Input correct Parameter 2 value with command.
15 MESSAGE: Primary DAM and Alternate DAM paths are same —
(HAFOERR 15)
CAUSE: Parameters 2 and 3 have the same value.
ACTION: Input correct Parameters 2 and 3 values with command.
16 MESSAGE: Invalid Alternate path for this Ldev — (HAFOERR 16)
CAUSE: Parameter 3 has an invalid value.
ACTION: Input correct Parameter 3 value with command.
17 MESSAGE: Not a valid Ldev — (HAFOERR 17)
CAUSE: Ldev input was not valid.
ACTION: Input correct Ldev with command.
52