General User Status Messages (Hafoerr - 1500 - HP e3000 MPE/iX Manual

1017 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 1017)
CAUSE: A message was received from the Device Manager with an invalid
class.
ACTION: Check to make sure that there are no mismatches between the
SYSGEN (io) section configuration and the HAFO (ha) section configuration.
All HAFO (ha) configured primary paths must match the SYSGEN (io) path
configuration for all HAFO Ldevs.
Check that there are no hardware problems and make sure no failover events
have occurred. If a failover event has occurred, fix the primary path and make
sure all HAFO Ldevs are operating on their primary path.
If the HAFO primary and SYSGEN (io) paths are in sync and all HAFO Ldevs
are operating on their primary paths, then call your HP Support Representative
for assistance.
GENERAL USER STATUS MESSAGES (HAFOERR — 1500...1505)
1500 MESSAGE: HAFO configuration file does not exist — (HAFOERR 1500)
CAUSE: The HAFO configuration file HAFOCONF cannot be opened.
ACTION: Run SYSGEN and the HAFOCONF should be built.
1501 MESSAGE: HAFO configuration file is corrupt — (HAFOERR 1501)
CAUSE: The HAFO configuration has an incorrect record size or has been
incorrectly formatted or does not have a correct checksum.
ACTION: Purge the file and run SYSGEN again.
1502 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 1502)
CAUSE: An unknown error has occurred in the HAFO utility.
ACTION: Call your HP support representative for assistance.
1503 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 1503)
CAUSE: An unknown error has occurred in the HASTAT Utility.
ACTION: Call your HP support representative for assistance.
Appendix-B
61