Ppt Access Errors (Hafoerr - 500 - HP e3000 MPE/iX Manual

203 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 203)
CAUSE: An End Of File condition was encountered while reading the
HAFOCONF file. The HAFOCONF file is a pre-formatted file and an End Of File
in this context is not a normal Condition and may indicate corruption.
ACTION: Call your HP Support Representative for assistance.
204 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 204)
CAUSE: An error occurred while executing an FREAD intrinsic call.
ACTION: Call your HP Support Representative for assistance.
205 MESSAGE: Maximum number of HAFO devices configured. Cannot add
to HAFO configuration — (HAFOERR 205)
CAUSE: All entries in the HAFOCONF configuration file have been allocated.
ACTION: List the entries in the HAFOCONF file and delete any entries not
needed.
206 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 206)
CAUSE: An End Of File condition was encountered during the execution of an
FUPDATE intrinsic call.
ACTION: Call our HP support representative for assistance.
207 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 207)
CAUSE: An error occurred during the execution of an FUPDATE intrinsic call.
ACTION: Call your HP support representative for assistance.
PPT ACCESS ERRORS (HAFOERR — 500...503)
500 MESSAGE: Invalid Primary Path for this Ldev. — (HAFOERR 500)
CAUSE: The primary path specified for this Ldev is not correct.
ACTION: Check the path specified for validity and try again.
501 MESSAGE: Invalid Alternate Path for this Ldev. — (HAFOERR 501)
CAUSE: The alternate path specified for this Ldev is not correct.
ACTION: Check the path specified for validity and try again.
502 MESSAGE: HAFO INTERNAL ERROR — (HAFOERR 502)
CAUSE: The Physical Path Table entry for this device was not found.
ACTION: Call your HP Support Representative for assistance.
Appendix-B
55