Control Panel - Genie GCL-GCX Manual

Control Panel

These operators include a full function control panel including a liquid crystal
display (LCD), calibration keys and Open, Close and Stop keys for on board
operator control. See Fig. 1. The open, close and stop keys function as a 3-button
wall control. The Display will show current operator conditions and calibration
information. Due to limited character space, some displays will be abbreviated.
See Appendix C (pgs. 10.5-10.7) for full display descriptions.
The operators also include a non-volatile memory. The unit will remember all
calibration settings plus error code and run code logs, if power is removed from
unit.
DANGER:
After power is supplied to the operator, Do Not make
contact with components inside the control panel except for the Keypad
Keys. Fig. 1.
Apply Power to the Operator Now
Control Operating Modes
Operator control boards operate in two modes: Run Mode and Calibration
Mode. The control board should normally operate in the Run Mode. The operator
is calibrated in Calibration Mode.
With the operator standing idle:
PRESS CAL/RUN TO TOGGLE BETWEEN OPERATING MODES.
• h T f e s r i d t s i l p y a n i l a c r b i
• The display in run mode will be one of the condition codes listed
in Appendix C.
WARNING:
DO NOT calibrate operator or operate door unless
doorway is in sight and free of obstructions. Keep people clear of
opening while door is moving.
GCL-GCX
Counter Door Operator
Section 6: Operator Setup Procedure
i t a n o m o e d s i S " T E C O L E S I D " . R
www.geniecompany.com
LCD DISPLAY
CAL
RUN
Calibration & Run
Mode Toggle Key.
Display Backlighting
Toggle Key.
Scroll Keys, used in
Calibration Mode.
Operation Keys, operate
unit like a 3-button
wall station.
OPEN
CLOSE
STOP
SET
SCROLL
CLEAR
SCROLL
Set/Clear Key, used to
reset and adjust
calibration settings.
Figure 1
08-12
6.1