Table of Contents
Advertisement
Line Voltage Wiring Fig. 1
WARNING
•
DO NOT apply power to operator until instructed to do so.
•
The Genie® Company recommends that line voltage wiring
be performed by a qualified electrician.
•
Be sure that electrical power has been disconnected from the
input power wires being connected to the operator prior to
handling these wires. An appropriate lock-out /tag-out procedure
is recommended.
•
Line voltage wiring must meet all local building codes.
•
Make sure operator voltage, phase and frequency nameplate
ratings are identical to the job site line voltage ratings.
•
Input power wiring must be properly sized for the operators
amperage rating located on the nameplate.
•
To reduce the risk of electric shock, make sure the chassis of this
unit is properly grounded.
1) Remove LINE VOLTAGE INPUT PLUG and install proper
fittings and 1/2"conduit.
2) Route proper LINE VOLTAGE wires into operator.
3) Locate LINE INPUT terminals on circuit board. Using
correct connectors, attach wires to LINE INPUTS, and GROUND
terminal.
•
Keep low voltage and line voltage wires separate.
•
Route all line voltage wires as shown.
•
Plug all unused conduit holes.
GCL-GCX
Counter Door Operator
Section 5: Wiring
Figure 1
www.geniecompany.com
CAL
SET
SCROLL
RUN
CLR
SCROLL
STB
ENAB
+ 4
S
S
B
S B
S B
S
Y
S
Y
VAC
EXT
IN LK
HOIST
IN LK
08-12
5.1
- Quick Links:
- Error Codes
Hide quick links:
Advertisement
Table of Contents
