Photocell Wiring - Genie GCL-GCX Manual

Commercial line counter door operator

Hide thumbs Also See for GCL-GCX:

Product manual (2 pages)

Specifications (2 pages)

Table Of Contents

Table of Contents

Series II Safe-T-Beam® Monitored Photocells

1) Monitored SERIES II (STB) photocells (P/N 38176R.S or OPAKPE.S) can be installed as shown in

Fig. 6. Wiring to these photocells can be connected to either terminal (they are

not polarity sensitive). ( Troubleshooting in Section 8).

NOTE: Installer must enable ODC STB in calibration mode. See page 6.7.

WARNING:

Actuating operator using constant contact on the CLOSE button will

override external reversing devices, including photocells.

2) To Mount Photocells: (Kit includes detailed Instructions).

•

Determine location for mounting. They do not need to be directly adjacent to

the door but must be somewhere along the wall where there will be an

unobstructed line between them. Fig 7.

•

Screws provided for mounting on soft material (wood, drywall, etc.)

•

They must extend out away from the wall sufficiently that no door hardware

breaks the plane of the photo-beam.

WARNING:

Photocell systems provide entrapment protection when

mounted near the doorway in such a way that the lower portion of an individual's

leg will break the photocell beam during normal walking conditions.

Commercial Non-Monitored Photocells

1) Nominal 24 Volt DC Commercial photocells with normally open contacts can be

connected as shown in Fig. 8.

NOTE: Blue wire supplies 20 – 40VDC. Photocells used must be compatible with this

voltage range.

NOTE: If no voltage is present at Blue wire, check fuse F-1 on Control board.

GCL-GCX

Counter Door Operator