Transfer Result Report; Multistep Transfer - Lanier LD225 Fax Manual

Reception Features
❒ If the Requesting Party specified a
destination fax number, Internet
Fax destination and IP-Fax desti-
nation programmed in Transfer
Station as the End Receiver, this
machine sends the document to
the destination according to the
User Parameter setting. See p.167
"User Parameters" (switch 32, bit 0).

-Multistep transfer

The principles of Transfer Stations
can be used to build up a multi-step
facsimile network where documents
are passed through several Transfer
Stations. By programming the Receiv-
5
ing Stations in a Transfer Station
Group, you can enable this machine
to transfer documents onto other
Transfer Stations.
For more information, contact your
service representative.
This function can only be used if the
machines are made by the same man-
ufacturer.
-Sending the Transfer Result
Report
This machine compares the fax number
of the Requesting Party with the Request-
ing Party's number programmed as a
Destination key. If the lower five digits
of the two numbers match, it sends
the Transfer Result Report to the Re-
questing Party.
For example:
• Requesting Party's own dial number:
001813-11112222
• Transfer Station's Destination key:
03-11112222
88

Transfer Result Report

Preparation
Program the Requesting Party fax
number into a Destination key in
the Transfer Station (this machine)
in advance.
Program your own fax number.
See p.192 "Transfer Report".
Program the Polling ID. See p.193
"Programming a Polling ID".
This reports whether transmission to
the Receiving Stations was successful
or not.
When the Transfer Station has trans-
ferred the document to all Receiving
Stations, it sends the Transfer Result
Report back to the Requesting Party.
The machine prints the report if it
cannot be sent back to the Requesting
Party.
Note
❒ You can select whether the Com-
munication Failure Report and
Transfer Result Report be auto-
matically printed using the User
Parameters. See p.167 "User Pa-
rameters" (switch 04, bit 1).
❒ You can set whether a portion of the
original image is printed on the re-
port with the User Parameters. See
p.167 "User Parameters" (switch
04, bit 7).
❒ "Unprogrammed" indicates that the
document could not be sent because
the end receiver's address is incorrect
or not programmed.
❒ "--" indicates that the Internet Fax
document was sent to the mail serv-
er programmed in this machine.