Using A Program - Lanier LD225 Fax Manual

Simplifying the Operation

Using a Program

Note
❒ Using the program causes the pre-
vious settings to be cleared.
❒ If you have no programmed desti-
nations or scan settings as programs,
select the program number, and
then enter the fax number of the
destination and select the scan set-
tings you require.
A
Make sure that the machine is in
facsimile mode and the standby
display is shown.
Note
❒ If the standby display is not shown,
press the {Facsimile} key.
B
Place the original.
C
Press the {Program} key.
7
D
Confirm that [Recall] is selected,
and press the registered program
number.
The standby display appears.
Then, the programmed fax number
is shown. Transmission Mode is
selected.
132
E
Press the {Start} key.
The fax number and specified time
are shown on the display, and the
machine starts to scan the original.
Transmission starts at the specified
time.
ZLFS310N