Sender Settings - Lanier LD225 Fax Manual

Sender Settings

This function tells receivers the fax
sender's identity.
If the sender's e-mail address is regis-
tered in the destination list, the send-
er can receive transmission results by
e-mail.
Also, if you enable the Stamp Sender
Name, the registered sender's name
(user name) appears on the receiver's
sheet, lists, and report.
Preparation
Before using this function, you must
register senders in the destination
list and specify the User Name as
[Sender]. See "Fax Destination",
General Settings Guide.
Note
❒ If user authentication is set, the user
logged in is set as sender. The trans-
mission result is sent to the logged-
in user's e-mail address.
❒ You can program one of the Quick
Operation keys with operations for
Sender Settings. Quick Operation
keys allow you to omit step B. See
p.145 "General Settings/Adjust-
ment".
❒ You can use Communication Result
Report, etc. to check usage status by
specified users. If user authentica-
tion is set, you can check usage by
logged-in users. See p.162 "Print-
ing Journal". If User ID is set to send-
er, you can count the number of
uses by each user. See "Authenti-
cation Information", General Set-
tings Guide.
A
Place the original, and then select
the scan settings you require.
Reference
p.15 "Placing Originals", Fac-
simile Reference <Basic Features>
p.34 "Scan Settings", Facsimile
Reference <Basic Features>
B
Press [Transmission Mode].
C
Press [Sender Settings].
D
Select a sender.
Sender Settings
1
5