Light Bulb - GE Monogram ZET1R Owner's Manual

Care and Cleaning
Wall Oven
Oven lights
Each oven is equipped with two halogen light
assemblies located on the side walls of the oven.
The lights come on when the door is opened or
when the oven is in a cooking cycle. The oven lights
do not come on during self-cleaning or
if the Sabbath Feature isset.
Each light assembly consists of a removable light
cover with two locking clips,a light compartment
with three light bulb sockets and three halogen light
bulbs.
A CAUTION: Before
replacing
the bulb, disconnect electrical power to the oven at
the main fuse or circuit breaker panel.
Be sure to let the light cover and bulb cool
completely.
For your safety, do not touch a hot bulb with bare
hands or a damp cloth.
To remove:
O Remove the racks from the oven. See the Full
extension oven racks section.
Using an adjustable wrench, remove the four
nuts holding the rack support over the light
assembly.
Remove the glass light cover by pulling its back
edge out and rolling it toward you.
Do not remove any screws.
NOTE:The two locking clips may fall from the
glass light cover. Upon replacement, they will
need to be placed in the correct position on
the light cover and pressed back into the light
compartment until seated.
Using gloves or a dry cloth, remove the burned-
out light bulb by pulling it straight out.
r]
r_
To replace:
Use a new !20-volt Halogen bulb, with G8 pins, not
to exceed 25 watts.
Replacement bulbs may be purchased by calling
800.626.2002.Order Part Number WB25TlO064.
NOTE.Higher wattage bulbs will damage your oven.
Using gloves or a dry cloth, remove the bulb
from its packaging. Do not touch the bulb with
bare fingers. Oil from bare fingers may cause hot
spots on the glass surface and lead to premature
failure of the bulb. If you do touch the glass,clean it
with alcohol prior to installation.
Pushthe bulb straight into the receptacle all the
way.
®
0 Replacethe light cover, by placing its front edge
under the front two tabs in the light
compartment. Rollthe back edge into place,
making sure that it is firmly seated.
NOTE: If
the locking
clips fell
from the
glass lens cover, hold
them on the cover, in
the correct position,
while replacing the
cover on the light
compartment.
Did locking
clips in .....
place on
ens cover
back edge,
Place
front
edge
of lens
}cover
under
front two
tabs
Press the light cover
into place
The light cover must be in place when using the
oven.
0
For improved lighting insidethe oven,
clean the glass cover frequently using a wet
cloth. This should be done when the oven is
off, disconnected from the power supply, and
completely cool.
Replacethe rack support with the slotted holes
over the rear bolts and the round holes over the
front bolts. Lightly secure with the four nuts
removed earlier, but do not over-tighten or the
enamel could be chipped.
Replacethe racks. See the Full extension oven
racks section.
Reconnect electrical power to the oven.
45