Table of Contents
Advertisement
Technical specification
Type of system
ISDN line
PSTN lines
Terminals
Extension capacity
Feature phone capacity
Standard 2-wire apparatus capacity
Extension loop resistance
System REN
Extension REN
Extension cabling
Main Equipment (CCU) 008
Maximum capacity system 8+32 CCU
Battery
Mains supply voltage
Maximum power consumption
Standard 2-wire telephone signalling
Standard 2-wire telephone recall
signal
Serial Port
Voice Mail Capacities
Music on hold
Tone on hold
External Music on hold
External Paging Port
System speed dials
Extension current and voltage feed
Dial tone duration
Programming
Mitel 3000 Australia Installation and Maintenance Manual
Hybrid/PBX
Max 8 ISDN (2B+D) Basic Rate lines
Max 16 PSTN lines
Max 40 standard terminal
Max 40 eight key Feature phone
Max 40 sixteen key Feature phone
Max 8 DSS console - Additional 32 programmable keys
40
40
40
67 ohms (0.4 km) 4-wire Feature phones
336 ohms (2 km) Standard Telephone
40
2 (see above for system max.)
Standard 4 wire
Twisted pair 0.5 mm cu
Height
390 mm
Width
295 mm
Depth
160 mm
Weight
3.5 kg
Height
390 mm
Width
595 mm
Depth
160 mm
Weight
6.1 kg
12 V/7.2 AH
230 10% V 50 Hz
150 watts
DTMF
Timed break
8 bit, no parity, 1 stop bit speed programmable 115k2,
2 Port 5 hours messaging capacity supporting 40
mailboxes, 10 Phantom Voice Boxes, 20 Group Boxes
4 Port 10 hours messaging capacity supporting 40
mailboxes, 10 Phantom Voice Boxes, 20 Group Boxes
8 Port 20 hours messaging capacity supporting 40
mailboxes, 10 Phantom Voice Boxes, 20 Group Boxes
Maximum message length is default at 3 minutes but is
programmable up to 5 minutes
External calls only
Internal or External source
200 ms on 200 ms off, 200 ms on 3.4 s off
Stereo jack connector
Input impedance 10k ohm
Nominal 775 mV RMS
Output Level 25 - 32mA
Max. 500
Voice
40 volts 25 mA constant current (nominal)
Data
40 volts 10 mA constant current (nominal)
10 s
Feature phone (default Extension 20) or PC Wizard through
60
Impedance 600 ohm
Advertisement
Table of Contents
