System Expansion
To equip the switch with more than eight extensions, two network Modules or a Broadband
Module, backplane, mounted on a second wall bracket, is needed.
The power must be disconnected to install the backplane or expansion
modules.
Installing the Backplane wall bracket
The CCU and Backplane brackets are identical. However when both are installed the
backplane bracket is inverted so that it meshes closely with the CCU bracket.
Locate the second bracket and mark the screw holes. Drill and plug the holes in the wall at
the marked locations. The holes should be deep enough to accept a 2.5 cm screw.
Mount the second bracket ensuring the two brackets are correctly interlocked and that
sufficient clearance is provided on all sides.
Mounting the CCU with two brackets
Slide the CCU on to the brackets from the left-hand side.
Ensure that the locking mechanism is activated.
Mounting the Backplane
Slide the backplane on from the right hand side.
Ensure the connector is fully mated with the CCU.
Mitel 3000 Australia Installation and Maintenance Manual
300mm min
13