Mitel 300 Installation And Maintenance Manual page 59

Software Upgrade Instructions
This is the procedure to be followed upgrading software on the Mitel 3000. Once connected
the same procedure applies if you are connected over a modem or via the Serial Port.

Connect to the switch using MPS

Retrieve and save the Database Programming using the "Get All and Save" command.

Retrieve and save the VM messages and greetings using the "Voice Mail BackUp
Manager" (under "System Programming")

Select the SW Flash location (Flash 1 or Flash 2)

Select the "Flash Files" tab and locate the pabxxx.olp file for the software version to be
downloaded

Send the pabxxxx.olp file to the switch.

The system will reset after the flash has been sent.

Allow at least 90 seconds for the reset then reconnect.

Send the saved database file using "Load and Send All"

Set the time and date by selecting "System Date and Time"

Restore the VM messages and greetings using the "Voice Mail Restore Manager"
Connecting to the Mitel 3000 locally
Select "Connect" button, on the MPS, select the "V24 via serial Port" radio button and press
the "Connect" button.
If a connection cannot be made, recheck the connections on your V24 cable and that the
correct serial port and speed are correct.
Connecting to the Mitel 3000 Remotely
Call the customer and ask them to transfer your call to "721", retrieve your call from hold and
hang up.
Then select the "Connect" button, on the MPS, select "PSTN", enter the remote telephone
number and select "Dial".
NOTE: If using the US Robotics modem please insert four commas after the telephone
number. There is no need to insert commas if using a Multitech modem.
If a connection cannot be made recheck, the connections on your modem, that the correct
serial port, and telephone number (including trunk access digit if necessary) are being used.
Also check that the correct modem is selected from the list on the "Setup/PSTN
Configuration" menu.
Retrieving the Customer Database.
This is done by selecting the "Get All and Save" button in the MPS. Select a file name and
location.
Mitel 3000 Australia Installation and Maintenance Manual
58